In order to create a workorder you should perform the following steps:
Press the Zoom link in the main page.
Select a landmark and press the Map link. There are various options to select the landmark as outlined in Section 3.4, “Zoom Page”.
Make sure that the workorder tool is enabled. Only one tool is enabled at a time. You can enable a tool by clicking on the radio button next to the tool icon.
Choose the area of interest center point by clicking onto the map. The area of interest is the area where you expect the maintenance problem.
The workorder tool icon changes to indicate that you have to defines the area of interest radius now. Do so by clicking on the map again.
Click on the [Accept Area of Interest] link.
Insert the appropriate information and then press the Save button.
Note that fields marked with a red "*" are mandatory (see Section 1.3.8, “Required Fields”).
Now print this page and hand it over to the maintenance team.
Click on the map to get back to the main page.